Preparing Practice Exam…
Please wait a moment while the system generates the exam questions, answers, and study session.
Please wait a moment while the system generates the exam questions, answers, and study session.
Implementing and Operating Cisco Enterprise Network Core Technologies (ENCOR) · Cisco
Select one answer.
Written by other learners. Comments can disagree with the marked answer — check the official documentation when in doubt.
cisco_R3(config)#ip sla responder ? auto-register Setup auto-register to hub tcp-connect Setup tcp-connect responder twamp Setup TWAMP responder udp-echo Setup udp-echo responder <cr> cisco_R3(config)#ip sla responder udp-echo ? ipaddress Permanent address port Permanent port cisco_R3(config)#ip sla responder udp-echo ipaddress ? WORD IP Address or IP HostName cisco_R3(config)#ip sla responder udp-echo ipaddress 2.2.2.2 ? port Permanent port cisco_R3(config)#ip sla responder udp-echo ipaddress 2.2.2.2 port 5000 cisco_R3(config)#ip sla responder cisco_R3(config)#
Tcp-connect involves establishing a full connection whereas udp-echo echo is used to measure response times and test end-to-end connectivity therefore C is the correct answer
In this example we deal with Per-direction jitter. We need IP SLAs Responder on a Destination Device. So we need to configure: R1>enable R1#configure terminal R1(config)#ip sla responder R1(config)#ip sla responder udp-echo 172.29.139.134 5000 R1(config)#end So, C is a valid answer.