350-401 Question 242

Community Discussion

Written by other learners. Comments can disagree with the marked answer — check the official documentation when in doubt.

• Chose B2

  flow record Recorder match ipv4 protocol match ipv4 source address match ipv4 destination address match transport source-port match transport destination-port collect interface input snmp ← ADD HERE ✅ collect interface output snmp ← ADD HERE ✅

• 1

  D it is: further explanation on the "option interface-table" This command causes the periodic sending of an options table, which will allow the collector to map the interface SNMP indexes provided in the flow records to interface names. The optional timeout can alter the frequency at which the reports are sent.

• Chose B2

  I think B is the correct answer. Traditionally, the SNMP interface table option (collect snmp if-table) is added under the flow record configuration to include SNMP-related information in the NetFlow records. flow record Recorder match ipv4 protocol match ipv4 source address match transport source-port match transport destination-port collect snmp if-table ! flow exporter Exporter destination 192.168.100.33 transport udp 2055 ! flow monitor Monitor exporter Exporter record Recorder ! et-analytics ip flow-export destination 192.168.100.33 2055 ! interface g0/2 ip flow monitor Monitor input ip flow monitor Monitor output et-analytics enable