300-410 Question 70

Community Discussion

Written by other learners. Comments can disagree with the marked answer — check the official documentation when in doubt.

• 7

  There is only one valid command: C1(config-router)#int L0 C1(config-if)# C1(config-if)# C1(config-if)# C1(config-if)# C1(config-if)#ip ospf net C1(config-if)#ip ospf network C1(config-if)#ip ospf network C1(config-if)#ip ospf network br C1(config-if)#ip ospf network broadcast C1(config-if)#ip ospf network broadcast C1(config-if)#ip ospf network broadcast % OSPF: Invalid type for interface Loopback0 C1(config-if)#ip ospf interface type network ^ % Invalid input detected at '^' marker. C1(config-if)#ip ospf interface area 10 ^ % Invalid input detected at '^' marker. C1(config-if)#ip ospf network point-to-point C1(config-if)#

• 1

  R1#show ip route 10.1.0.0 Routing entry for 10.1.0.0/24 Known via "ospf 1", distance 110, metric 20, type extern 2, forward metric 20 Last update from 192.168.12.2 on Ethernet0/0, 00:16:54 ago Routing Descriptor Blocks: * 192.168.13.2, from 10.4.0.1, 00:16:54 ago, via Ethernet0/1 Route metric is 20, traffic share count is 1 192.168.12.2, from 10.4.0.1, 00:16:54 ago, via Ethernet0/0 Route metric is 20, traffic share count is 1 R1#

• 3

  The network type broadcast is not accepted in the loopback interfaces. R4(config-if)#ip ospf network broadcast % OSPF: Invalid type for interface Loopback0 So for allow to exchange the loopback as not as a /32 network the only option that we have is use the command ip ospf network point-to-point command under the loopback interface