Preparing Practice Exam…
Please wait a moment while the system generates the exam questions, answers, and study session.
Please wait a moment while the system generates the exam questions, answers, and study session.
Cisco Certified Network Associate (CCNA) · Cisco
Select 2 answers.
This question asks for 2 answers, but our data marks only 1. Compare with the community discussion below for the full answer.
Written by other learners. Comments can disagree with the marked answer — check the official documentation when in doubt.
no switchprot = L3 ACTIVE = LACP = open standart on is static
Also, I meant to pick D and E, not C & E. Its' 4AM.
Definitely start w/ C (as per open standard w/c is LACP - active) Then, follow it w/ E (with a caveat) About answer C; you can't issue "no switchport" on a port-channel interface. You do that under interface/interface range configuration, before you even create the channel group. So there are two more steps beforehand (first selecting the range of interfaces, then creating the channel group). And btw, this IP thing is only for L3 EtherChannel/LAG. L2 LAG does not require an IP. Now regarding answer E (w/ a caveat); in PT version 8.2.2 0400, you can't immediately issue the "switchport mode trunk" (answer E) either. Not sure if this is the case w/ live equipment but, you would first have to issue the command "encapsulation dot1q". Only after that will you be able to issue " switchport mode trunk", which is a necessary step for a LAG.