Preparing Practice Exam…
Please wait a moment while the system generates the exam questions, answers, and study session.
Please wait a moment while the system generates the exam questions, answers, and study session.
Question 34 of 105
Free Preview · 105 of 350 · questions 1–105 of 350 are free. Sign up free to sync your progress across devices.
Select 2 answers.
This question asks for 2 answers, but our data marks only 1. Compare with the community discussion below for the full answer.
Written by other learners. Comments can disagree with the marked answer — check the official documentation when in doubt.
1. The cluster compares the number of monitored interfaces that have a status of up. The member with the most available monitored interfaces becomes the primary. 2. The cluster compares the HA uptime of each member. The member with the highest HA uptime, by at least five minutes, becomes the primary. 3. The member with the highest priority becomes the primary. 4. The member with the highest serial number becomes the primary.
Correct: A. FortiGate SN FGVM010000065036 HA uptime has been reset. (reset_cnt=1) D. FortiGate SN FGVM010000064692 has the higher HA priority. (by discard) Incorrect: B. FortiGate devices are not in sync because one device is down. (not in exhibit) C. FortiGate SN FGVM010000064692 is the primary because of higher HA uptime. (no greater than 300 sec) Note: In this exhibit the primary unit is FGVM...65036. Tested in lab, the primary unit is always the one with ha_prio/o=0/0. When there is a failover event the new unit assumes primary role and gets ha_prio/o=0/0
Base on this document, answer should be A and D. https://community.fortinet.com/t5/FortiGate/Technical-Tip-Restoring-HA-master-role-after-a-failover-using/ta-p/197460