Implementing and Operating Cisco Enterprise Network Core Technologies (ENCOR) Practice Mode

Community Discussion

Written by other learners. Comments can disagree with the marked answer — check the official documentation when in doubt.

• Chose B1

  Router1(config-if)# standby 1 ip 192.168.1.1 and Router2(config-if)# standby 1 ip 192.168.1.1 must be the same

• 2

  B. is correct Verified in CML 2: R2(config-if)#int g0/1 R2(config-if)#standby 1 ip 192.168.1.25 R2(config-if)# *Sep 19 15:37:54.589: %HSRP-4-DIFFVIP1: GigabitEthernet0/1 Grp 1 active routers virtual IP address 192.168.1.3 is different to the locally configured address 192.168.1.25 *Sep 19 15:38:14.110: %HSRP-5-STATECHANGE: GigabitEthernet0/1 Grp 1 state Speak -> Standby *Sep 19 15:38:26.004: %HSRP-4-DIFFVIP1: GigabitEthernet0/1 Grp 1 active routers virtual IP address 192.168.1.3 is different to the locally configured address 192.168.1.25 *Sep 19 15:38:56.261: %HSRP-4-DIFFVIP1: GigabitEthernet0/1 Grp 1 active routers virtual IP address 192.168.1.3 is different to the locally configured address 192.168.1.25 R2(config-if)#standby 1 ip 192.168.1.3 No more messages...

• 3

  The question makes zero sense, analyzing the log message notwithstanding An network engineer configures the router with 10.1.1.1 and now has to change the router he is *currently configuring with 10.1.1.1 to 10.1.1.1* Unless the engineer made a typo and typed .25 when he meant to type .1 Unless he watches the terminal of the other router as he configures the new router, but that STILL doesn't make sense. This is the typical rotten, dirty, low-down, sneaky question I have come to expect of Cisco, instead of asking clear-cut questions, they leave everything open to 2-3 different interpretations. If a customer gave me this info I would tell him to go away and come back when he has more than just confusing nonsense as info.