Implementing Cisco Enterprise Advanced Routing and Services (ENARSI) Practice Mode

Community Discussion

Written by other learners. Comments can disagree with the marked answer — check the official documentation when in doubt.

• Chose C1

  C is correct. From Cisco command reference examples: Device(config-if)# ospfv3 1 area 1 ipv4 --- Enables OSPFv3 on an interface with the IPv4 or IPv6 AF. address-family ipv4 unicast --- Enters IPv4 address family configuration mode for OSPFv3.

• Chose C4

  R1(config-if)#ipv6 enable R1(config-if)#ospfv3 1 ipv4 area 0 R1(config-if)#do show run | sec ospf ospfv3 1 ipv4 area 0 router ospfv3 1 ! address-family ipv4 unicast exit-address-family Lab it people... It's "C"

• Chose C1

  The correct answer is c